New Smoker build

Post Reply
BlueMonkey
User
User
Posts: 57
Joined: Wed Apr 13, 2016 10:36
Location: Gold Coast

New Smoker build

Post by BlueMonkey » Sun Jan 01, 2017 15:23

Well, first day of the New Year and the temperature was a shade under 34C ( 94 F) at 08:30 this morning.

What better day to turn to a new Cold smoker..... :roll:

Thought what I may do is post some pics on the way so that others could follow, or offer advise before I make a big mistake.....

My Idea is to make a block smoker similar to the one demonstrated on the Meat and Sausages site, but with a few small changes, and begin by paying with my configurations before I mortar it up, so blocks just resting on themselves.

This will be a work in progress, so don't expect finished pictures for some time ( Months)...

First, here is a photo of the Site, and the boxing for the Slab.
Image

As you can see, it is set back slightly from a bank, with another bank behind. I will use the front bank to hold my fire-pit. ( Secondary source, as I will also have a Venturi system rigged.

Next, I have used single besser blocks (don't know your term for them) as the flue. dont want to use galvanised pipe, cant find concrete, cant buy clay, and the sewer pipes as second hand just doesnt seem right.... '

I will run it under the concrete floor, then up into the middle. As I cannot get an elbow or 45 degree bend I have improvised. Please see the photo to illustrate as I will find it hard to explain. I cut the side off 1 of the blocks to make a U channel block ( leaving an inch at the bottom where it will sit on the ground), then butt this up to the laid flue, and cut another block to fit on top to take the outlet to the floor level. Sorry, probably confused you all.

Please see the following pictures....
Image

Put together and roughed in. Please note I will be laying in sand etc, this was just to see how it would work....
Image

Thanks for your time. Any advise welcomed....
User avatar
Butterbean
Moderator
Moderator
Posts: 1866
Joined: Mon Mar 05, 2012 04:10
Location: South Georgia

Post by Butterbean » Sun Jan 01, 2017 18:34

Looks nice. I like your idea on the use of the blocks. You may have already thought of this but when I did mine I found a piece of expanded metal and layed it over the opening of the smoke pipe and bent the edges down where it would fit fairly flush then when the concrete was poured this glued this in place so I can stand on it without twisting my ankle. I also cut another piece of sheet metal that can be placed over the top of the opening to use as a plug if needed. (hasn't been needed yet)
Post Reply